- Phillips #2 Screwdriver
- Soldering Iron
- Solder
- Phillips #1 Screwdriver
- Smart Wrench
When remote is pass-thru, and main logic board. First plugged in. Dead or very low battery Check and charge battery. Blown fuse or fuses on main logic. Replace blown fuse(s) Inline circuit breaker/fuse Reset breaker / replace fuse. Tripped or blown Indicator light turns Insufficient voltage from battery to Unplug remote wait 15 seconds.
No parts specified.
![Logic Board Shooter Blender Logic Board Shooter Blender](/uploads/1/2/5/6/125623228/681741077.jpg)
- Remove the Blender Container from the Blender Base.
- Flip the blender so the bottom is facing you.
- Unscrew the 16mm screws located on the plastic bottom from the blender base using a Phillips #2 screwdriver.
- Remove the plastic bottom from the base of the blender.
- Holding the center of the fan, grip the knob in the center of the top of the blender with a wrench and twist the wrench counterclockwise.
- Carefully remove the motor and fan from the base of the blender.
- Now, gently pull the white wire that is connected to the base and the motor.
- Be careful, as there is a spring behind the contact points, that might try to shoot out and hurt you.
- Now, turn the motor over, and remove the black wire from the motor.
- Again, be warned as the is another spring that wants to shoot out and hurt you here as well.
- Now de-solder the yellow wire from circuit board. De-solder the wire following these instructions.
- Be careful, as there is another, black wire, nearby that you do not want to de-solder.
- Locate the four 11mm screws in the circuit board.
- Unscrew the four screws using the Phillips #1 screwdriver.
- Desolder the circuit board from the base at the indicated point, following the directions by clicking here.
- Now separate the circuit board from the base.
- You will see that the circuit board is still attached by a red wire and a black wire.
- Flip the circuit board back over and desolder at the indicated points following the directions given here.
Now your circuit board is ready to be replaced. To reassemble your device, follow these instructions in reverse order.
![Logic board shooter blender download Logic board shooter blender download](https://o.aolcdn.com/images/dims?quality=85&image_uri=http%3A%2F%2Fwww.blogcdn.com%2Fmassively.joystiq.com%2Fmedia%2F2012%2F10%2Fblender-rock-epl-1031.jpg&client=amp-blogside-v2&signature=8db8fead84ec8a356c12485e872079d26a18518b)
Now your circuit board is ready to be replaced. To reassemble your device, follow these instructions in reverse order.
2 other people completed this guide.
Embed this guide
Choose a size and copy the code below to embed this guide as a small widget on your site / forum.